My current internet setup is like this (which is common for most people).

fiber line from ISP <-> ISP fiber modem <-> Personal wifi router <-> switch

This is working fine with no issues. But I need to power two devices. I want to reduce this to a single device.

fiber line from ISP <-> Modem+Firewall PC <-> Switch <-> AP1,AP2...

From my initial research, what I need is an SFP module which can be attached to a PC which supports SFP. OPNsense should be able to handle most SFP modules.

What is the community’s take on this? Is this worth the effort? Can I find a mini-PC which supports SFP? Will it be cost effective?

  • DaGeek247@fedia.io
    4·
    7 hours ago

    It very strongly depends on which ISP they have. There’s a few that make it easy. There’s a much larger number that can be hacked by a competent pc person (which I’ve done). There’s also a small amount who have worked to make it impossible / hard to do, and don’t have any public info on the process.

    My ISP is att fiber, and all I had to do was change the vlan id on the outgoing side and match the ip settings to make it work. I used the guides from https://pon.wiki/ to do it, and the discord is also incredibly helpful.

    Of note, this used to be impossible / very difficult so you’ll still find forum posts saying it can’t be done. However, a couple nerds have changed that over the past two years so make sure your info is up to date before deciding it can’t be done for your specific setup.